Skip to content
Home / Industries / Aerospace & aviation
Industry 07

Aerospace & aviation

Every kilogram flies for twenty years. Aerospace buyers do not shop on price per metre — they buy a documented, repeatable material whose behaviour is proven before the first flight.

What this application demands

The three requirements that decide whether the wire qualifies here.

Traceable melt source

Heat number, melt practice and mill certificate travel with every spool. Airworthiness review does not accept a typical value — it asks which heat this wire came from.

Fatigue under thermal cycling

Anti-icing elements and sensor leads cycle from −55 °C to working temperature thousands of times. Grain size and temper decide whether the wire survives that, not tensile alone.

Outgassing and cleanliness

Wire that goes into a sealed avionics enclosure or a vacuum-served sensor must arrive free of drawing lubricant, with a documented cleaning route.

Recommended grades and sizes

Starting points — the final choice follows the specification, not our preference.

ApplicationGradeTypical sizeWhy
Anti-icing heater elementNi80Cr200.2–0.6 mmStable resistance over long cycles
Engine bleed-air sensor leadNi200 / Ni2010.15–0.50 mmHigh purity, low drift at temperature
Exhaust and hot-section hardwareInconel 625 / 7181.0–6.0 mmStrength and oxidation above 650 °C
Spring and fastener stockInconel X-7500.5–3.0 mmAge-hardened, resists relaxation
Thermocouple and RTD leadNi200 / Constantan0.10–0.50 mmMatched EMF, T- and K-type assemblies
Actuator and connector wireMonel 400 / Ni2010.3–2.0 mmCorrosion resistance, solderability

Products used in this industry

Asked by engineers in this industry

Can you supply against an AMS or ASTM specification?

Yes. We work to AMS 5662 / 5663 / 5664, ASTM B637 and equivalent GB grades, and the quotation states which specification the heat was produced to. If your drawing cites a revision we do not hold, tell us before ordering so we can confirm rather than assume.

What documentation ships with an aerospace lot?

EN 10204 3.1 mill certificate with heat number and chemistry, dimensional report, and a certificate of conformity to the ordered specification. First-article inspection reports and PPAP-style packages are available for programme work.

Do you offer ultrasonic or eddy-current testing?

Third-party inspection by SGS, BV or TÜV can be arranged on request. In-house we report diameter, ovality, surface condition and mechanical properties per lot; specify the NDT method on the order if it is a requirement.

Is the wire cleaned for vacuum or sealed assemblies?

Standard delivery is lubricant-free after final drawing and degreasing, spooled on clean carriers. For vacuum service we can supply with a documented cleaning route and low-outgassing packaging — state the application on the enquiry.

Send the specification, not just the grade name.

Alloy, temper, diameter, specification revision and the environment it flies in — with those we can quote a material your design authority can sign off.

WhatsApp UsContact Us