Skip to content
Home / Industries / Medical equipment
Industry 08

Medical equipment

When the wire sits inside a device that touches a patient, consistency stops being a quality target and becomes the qualification itself — the hundredth spool must behave like the first.

What this application demands

The three requirements that decide whether the wire qualifies here.

Tolerance you can calibrate to

Heating probes and analytical filaments are specified in hundredths of a millimetre. Diameter and ovality are reported per lot so the device calibration holds across builds.

Surface free of residue

Drawing lubricant or oxide left on the surface changes both heat transfer and biocompatibility review. Final degreasing and clean spooling are part of the delivery, not an extra.

Repeatable resistance

A disposable heating device is designed around one resistance per metre. Lot-to-lot variation is what turns a validated design into a re-validation.

Recommended grades and sizes

Starting points — final choice follows the device validation and the cleaning route.

ApplicationGradeTypical sizeWhy
Heating probe elementNi80Cr200.05–0.30 mmFine gauge, stable resistance
Disposable heating deviceNi60Cr150.08–0.25 mmLower cost, adequate cycle life
Analytical instrument filamentNi200 / Ni2010.05–0.20 mmHigh purity, low outgassing
Sensor and electrode leadNi2000.10–0.40 mmConsistent EMF, weldable
Precision resistance componentConstantan CuNi440.05–0.30 mmFlat resistance against temperature
Spring and contact partNi201 / Monel 4000.15–0.60 mmCorrosion resistance, formability

Products used in this industry

Asked by engineers in this industry

Do you supply material with a biocompatibility statement?

We supply the alloy and its mill certificate; we are a wire mill, not a device manufacturer, so we do not issue biocompatibility certification for a finished device. What we can provide is full chemistry, traceability and a documented clean-surface route so your own validation has a defined input.

How tight can you hold diameter on fine wire?

On 0.05–0.30 mm nichrome and nickel wire we routinely hold the tolerances quoted on the product page, with diameter and ovality reported per lot. If your probe design needs tighter than our standard band, send the drawing — we will confirm what is achievable rather than quote optimistically.

Is the wire cleaned before packing?

Yes. Final drawing is followed by degreasing, and spools are packed clean. For devices where residue matters, state the requirement on the order so the cleaning route is written into the confirmation.

Can you keep lot-to-lot resistance consistent for a validated design?

Resistance per metre is reported with each lot and we can work to a declared window rather than a typical value. Tell us the window your design assumes; if it falls outside what the alloy naturally gives, we will say so before you order.

Tell us the device, and the tolerance it needs.

Gauge, resistance window, cleaning requirement and annual volume — with those we can quote a wire that keeps your validation valid.

WhatsApp UsContact Us