Millions of elements, each one having to deliver the same wattage. Resistance tolerance and surface consistency matter more here than absolute performance.
The three requirements that decide whether the wire works here.
Element wattage has to stay inside the tolerance your controller and process can absorb, lot after lot.
Oxide scale growth, sag and grain growth set the replacement interval — not the data sheet maximum.
Traceability from melt to spool, with the certificate formats your quality system expects.
Starting points — the final choice follows the atmosphere, cycle and geometry.
| Application | Grade | Typical size | Why |
|---|---|---|---|
| Hair dryer / fan heater | Ni80Cr20 | 0.15–0.40 mm | Fast heat-up, high surface load |
| Toaster / grill | 0Cr21Al6 ribbon | 0.3 × 3 mm | Visible glowing element, low cost |
| Oven element | Ni60Cr15 | 0.5–1.0 mm | Balanced cost and oxidation life |
| Cartridge heater | Ni80Cr20 | 0.2–0.5 mm | Consistent resistance per metre |
| Sealing bar | Ni80Cr20 flat | 0.2 × 2 mm | Uniform temperature along the bar |
Standard is ±5% on resistance per metre; ±3% is available on request for element lines running automated winding. Diameter tolerance follows P5 or P4 as quoted.
Yes, with PPAP-style documentation, first-article inspection reports and lot traceability. We routinely supply European and Turkish appliance element makers.
Bright annealed with a controlled surface is standard. For visible elements we can supply a specified surface roughness and check it per lot.
Service temperature, atmosphere, cycle time and joint design — with those four numbers we can recommend a grade and size with the life you need.