Skip to content
Home / Industries / Packaging machinery
Industry 04

Packaging machinery

A sealing bar that runs two degrees hot scorches the film; two degrees cold gives a weak seal. Repeatable resistance is the whole game.

What this application demands

The three requirements that decide whether the wire works here.

Repeatable resistance

Element wattage has to stay inside the tolerance your controller and process can absorb, lot after lot.

Life at temperature

Oxide scale growth, sag and grain growth set the replacement interval — not the data sheet maximum.

Documented lots

Traceability from melt to spool, with the certificate formats your quality system expects.

Recommended grades and sizes

Starting points — the final choice follows the atmosphere, cycle and geometry.

ApplicationGradeTypical sizeWhy
Sealing bandNi80Cr20 flat0.2 × 1.5 mmUniform temperature along the bar
Impulse sealerNi80Cr200.3–0.6 mmFast thermal response
Hot-cut knifeNi80Cr200.5–1.0 mmEdge retention at 400 °C
Thermocouple leadConstantan + Ni80Cr20 (Type E) or Cu (Type T)0.2–0.5 mmConstantan is the negative leg of both types

Products used in this industry

Asked by engineers in this industry

Can you match the resistance of an existing element?

Yes — send a sample or the resistance per metre and we will match within ±3%, so the machine does not need re-tuning after a wire change.

Why does our sealing band fail at one end?

Almost always uneven clamping pressure or a cold end where the terminal is. Check the terminal joint first; if the band itself is oxidising unevenly, the surface load is too high for the cycle time.

Do you supply pre-formed sealing bands?

We supply flat wire cut to length and, for volume orders, pre-formed with welded terminals to your drawing.

Tell us the application, not just the grade.

Service temperature, atmosphere, cycle time and joint design — with those four numbers we can recommend a grade and size with the life you need.

WhatsApp UsContact Us