Three jobs that show how grade selection, tolerance control and process review actually play out. Anonymised, with the numbers that mattered.
A Turkish heat-treatment shop replaced nichrome elements that failed every 9 months with 0Cr25Al5 drawn to a matched resistance — and stopped planning shutdowns around element changes.
A cell assembler in Eastern Europe was seeing intermittent weld failures traced to strip thickness variation. We supplied 0.15 mm Ni200 strip at ±0.005 mm with controlled burr — and the weld schedule finally repeated.
A fabricator building chemical piping in 2205 duplex needed filler wire with a ferrite balance that would survive both the WPS qualification and the chloride service behind it.
A failure mode or scrap rate, not a vague dissatisfaction.
Resistance, thickness, heat chemistry — measured, not assumed.
MTR, COC and lot traceability tied to the shipped material.
Parameters checked by our engineers before first production run.
Send the application data. If we have seen it before, the answer is faster than you expect.