Where the wire is a functional material rather than a heating element: current paths, sensor legs, seal joints and precision resistors.
The three requirements that decide whether the wire works here.
A shunt or precision resistor is calibrated against resistance, so lot-to-lot drift moves the reading itself — not just the wattage of a heater.
Where the wire meets copper or solder, the thermoelectric voltage at the joint has to stay small against the signal being measured.
Trace elements and surface residue change solderability and contact resistance, so ICP chemistry and cleaning records ship with the lot.
Starting points — the final choice follows the atmosphere, cycle and geometry.
| Application | Grade | Typical size | Why |
|---|---|---|---|
| Battery tab | Ni200 strip | 0.05–0.30 mm | Ultrasonic weld to Al/Cu |
| Shunt resistor | Manganin | 0.05–1.0 mm | ±10 ppm/K, low thermal EMF |
| Sensor leg | Constantan | 0.10–0.50 mm | Type T / Type J thermocouples |
| Glass-to-metal seal | 4J29 Kovar | 0.10–2.0 mm | CTE matched to borosilicate |
| Photovoltaic ribbon | Ni-plated Cu (by request) | per drawing | Solderable interconnect |
99.9% (4N) routinely, 99.99% (5N) on request with GDMS or ICP-MS trace analysis. For sputtering targets and evaporation sources this is usually the deciding document.
Yes — 4J29 is the GB designation for the Fe-29Ni-17Co expansion alloy known as Kovar or ASTM F15. We quote both designations on the certificate so either drawing can be satisfied.
Yes — from 1 kg for wire and 5 kg for strip, so a design team can run seal or weld trials before committing to production volume.
Service temperature, atmosphere, cycle time and joint design — with those four numbers we can recommend a grade and size with the life you need.