Skip to content
Home / Industries / Vacuum & battery equipment
Industry 03

Vacuum & battery equipment

Low gas content, no drawing residue and a thickness tolerance that lets a spot-weld schedule repeat — the three things vacuum and cell assembly actually need.

What this application demands

The three requirements that decide whether the wire works here.

Clean, dry surface

Drawing residue and handling oil are the main source of outgassing and weld porosity — so the wire is ultrasonically degreased, dry-packed and shipped with a cleaning certificate.

Thickness and edge control

A tab weld schedule only repeats if thickness and burr stay inside a narrow window, coil after coil. Burrs also puncture separator film downstream.

Lot traceability

Heat number on the spool label, MTR and cleaning record together, so a finished cell lot can be traced back to one melt of nickel.

Recommended grades and sizes

Starting points — the final choice follows the atmosphere, cycle and geometry.

ApplicationGradeTypical sizeWhy
Battery tabNi200 strip0.10–0.30 mm, ±0.005Ultrasonic or spot welded to Al/Cu
Cell connectorNi201 strip0.15–0.50 mmBetter where heat is applied
Vacuum feedthroughNi200 wire0.20–2.0 mmLow outgassing after cleaning
Electrode / anodeNi200 barper drawingPlating and electrolysis
Evaporation filament99.9% Ni wire0.5–1.5 mmLow trace elements

Products used in this industry

Asked by engineers in this industry

What is the outgassing performance of your nickel wire?

Bright annealed wire is ultrasonically degreased and packed dry; we can supply a cleaning certificate. Actual outgassing depends on your vacuum bake-out, so we quote surface cleanliness rather than a chamber number.

How flat and how thick is battery tab strip?

Thickness tolerance ±0.005 mm and camber under 1 mm per metre on tab strip. Edge quality is slit, burr-controlled, because burrs puncture separator film.

Do you supply strip on traverse-wound coils?

Yes, traverse wound on plastic spools or in level-wound coils up to 200 kg, with interleaving paper on request for scratch-sensitive surfaces.

Tell us the application, not just the grade.

Service temperature, atmosphere, cycle time and joint design — with those four numbers we can recommend a grade and size with the life you need.

WhatsApp UsContact Us